Helical springs made of round wire and rod - Part 2: Information to be given in order to obtain the cold formed tension springs required, printed form B
Abstract
This document is applicable without restriction solely to cold formed helical tension springs made from wire and bar. It specifies a form in A4 format according to DIN EN ISO 216 for the information to be supplied on these tension springs. NOTE 1 When designing tension springs from sectional steel, it shall be noted that non-standardized sections cannot always be supplied. In many cases, however, the square section can be replaced by a circular cross-section. NOTE 2 If tension springs made of sectional steels cannot be avoided in special cases, e.g. for installation reasons, it is necessary to consult the spring manufacturer. The form can then be completed according to corresponding agreements about design and permissible deviations.
Begin
2024-04-16
Planned document number
DIN 2099-2
Project number
02600103
