Abstract

This document specifies requirements and test methods for the physical properties of powered toothbrushes in order to promote the safety of these products for their intended use. There are different technologies of powered toothbrushes. Common features of those powered toothbrushes to which this document applies are: — a battery; — a motor; — a mechanical or magnetic drive system; — a moving brush head with tufted filaments. Powered toothbrushes can have a moving brush head with different motions (e.g. oscillating-rotating, side-by-side), frequencies and velocities. The requirements listed in this document apply to all types of powered toothbrushes. However, there is a possibility that some requirements are not applicable for all types, for example brush head plate retention can only be applied if the brush has a head portion that might get detached from the brush shaft. In addition, for the filaments end-rounding requirements, this document does not apply to particular filament types which are very thin (less than 0,1 mm outside diameter) or have no sharp edges (e.g. tapered, feathered, with split tips, or spherical cap) or non-synthetic filaments, where applying end-rounding process is inappropriate or impossible. This document is not applicable to other types of powered oral hygiene devices (such as powered interdental brushes) or manual toothbrushes.

Begin

2023-10-19

WI

00055558

Planned document number

DIN EN ISO 20127

Project number

01402380

Responsible national committee

NA 014-00-19 AA - Oral hygiene products  

Responsible european committee

CEN/TC 55 - Dentistry  

Responsible international committee

ISO/TC 106/SC 7/WG 2 - Powered oral hygiene devices  

draft standard

Dentistry - Physical properties of powered toothbrushes (ISO/DIS 20127:2024); German and English version prEN ISO 20127:2024
2024-05
Order from DIN Media

previous edition(s)

Dentistry - Physical properties of powered toothbrushes (ISO 20127:2020); German version EN ISO 20127:2020
2020-12

Order from DIN Media