• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Project

Intelligent transport systems - eSafety - Part 5: eCall for UNECE category L1 and L3 powered two-wheeled vehicles; German version FprEN 17249-5:2024

Abstract

Upgrade of TS 17249-2 to EN with the same scope as the TS: In respect of 112-eCall (operating requirements defined in EN 16072), this document defines adaptations to eCall specifications defined in EN 16072 and other related documents to enable the provision of eCall for Powered Two Wheel Vehicles . As with the existing provisions for eCall for Category M1/N1 vehicles, these are specified within the paradigm of being OEM fit equipment supplied with new vehicles. For the purposes of the present document, the P2WV ‘L' categories, as defined in Directive 2002/24/EC, Regulation (EU) No 168/2013, UNECE and as referenced/specified in EN 15722 apply. This document includes only the requirements for Category L1 and L3 P2WV (vehicle based) with the exception of L1e-A (powered cycle), although other documents may subject other ‘L' subcategories to use this document. Other Technical Specifications may be prepared for other UNECE category ‘L' variants. This document is a revision of TS 17249-5:2018 based on results achieved in sAFE project (sub-activity 3.5) [11] to obtain a specification allowing a more practical implementation of eCall for P2WVs. The specifications herein relate only to the provision of pan-European eCall, and does not provide specifications for third party service provision of eCall. Other than in the 112-eCall paradigm, which involves a direct call from the vehicle to the most appropriate PSAP, third party service provision involves the support of an intermediary third party service provider before the call is forwarded to the PSAP. NOTE 1 The provision of eCall for vehicles via the aftermarket (post sales and registration), and the operational requirements for any such aftermarket solution. will be the subject of other work, that will use the specifications of this document as a principle reference point.

Begin

2022-11-28

WI

00278604

Planned document number

DIN EN 17249-5

Project number

05202966

Responsible national committee

NA 052-00-71-15 GAK - Joint working group NAAutomobil/DKE: e-Call  

Responsible european committee

CEN/TC 278/WG 15 - eSafety  

draft standard

Intelligent transport systems - eSafety - Part 5: eCall for UNECE category L1 and L3 powered two-wheeled vehicles; German and English version prEN 17249-5:2024
2024-01
Order from DIN Media

previous edition(s)

Intelligent transport systems - eSafety - Part 5: eCall for UNECE category L1 and L3 powered two-wheeled vehicles; German version CEN/TS 17249-5:2022
2022-10

Order from DIN Media

Contact

Eric Wern

Behrenstr. 35
10117 Berlin

Tel.: +49 30 897842-323

Send message to contact