• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Project

Aerospace series - Quality management systems - Variation management of key characteristics; German and English version prEN 9103:2022

Abstract

1.1 General This document is primarily intended to apply to new parts and products intended to be produced in an on-going production phase but can also be applied to parts currently in production (e.g. manufacturing, maintenance). This document is applicable to all production processes that influence the variation of KCs, as well as maintenance and service processes in which KCs are identified. It applies to organizations for assemblies and all levels of parts within an assembly, down to the basic materials including castings and forgings, and to organizations that are responsible for producing the design characteristics of the product. The variation control process begins with product definition, typically stated in the design documentation (e.g. digital model, engineering drawing, specification) which identifies KCs, and leads to a variation management process for those KCs. This process may also be used for producer-identified KCs (e.g. process KCs, additional/substitute product KCs). Producers and their subcontractors are responsible for flow down of the standard requirements to those external providers, who produce design characteristics and provide production and service provisions, to ensure that KCs conform to the customer´s requirements. 1.2 Purpose This document is designed to drive the improvement of manufacturing and maintenance processes through adequate planning and effective management of KC variation. This focus is intended to improve uniformity (less variation or minimum variation of product KCs) and acceptance probability of the end product. NOTE Control of a product or process KC per this document does not constitute, nor imply acceptance of the resulting product. If variation management, under this document, is to be part of an acceptance decision, the requirements need to be specified in the applicable product acceptance plan or contract. 1.3 Convention The following conventions are used in this document: - "shall" indicates a requirement; - "should" indicates a recommendation; - "may" indicates a permission; - "can" indicates a possibility or a capability.

Begin

2022-02-28

WI

04004750

Planned document number

DIN EN 9103

Project number

13116611

Responsible national committee

NA 131-05-01 AA - Quality and management processes  

Responsible european committee

ASD-STAN/D 6/WG 1 - EAQG European Aerospace Quality Group  

draft standard

Aerospace series - Quality management systems - Variation management of key characteristics; German and English version prEN 9103:2022
2023-01
Order from DIN Media

previous edition(s)

Aerospace series - Quality management systems - Variation management of key characteristics; German and English version EN 9103:2014 + AC:2015
2017-02

Order from DIN Media

Contact

Stella Kalantzis

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2369
Fax: +49 30 2601-42369

Send message to contact