• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Project

Corrosion of metals and alloys - Corrosion and fouling in industrial cooling water systems - Part 1: Guidelines and requirements for conducting pilot-scale evaluation of corrosion and fouling control additives for open recirculating cooling water systems (ISO/FDIS 16784-1:2024); German version FprEN ISO 16784 1:2024

Abstract

This document specifies general requirements and parameters for the pilot test evaluation of corrosion and scaling control additives in open recirculating cooling water systems. This document covers parameters including test unit design, operation, water quality and contamination. It also covers the design and operation of pilot test devices as well as parameters to be evaluated in pilot test units. This document covers the criteria that are used in pilot scale testing programmes for selecting water treatment programmes for specific recirculating cooling water systems. This document is only applicable to open recirculating cooling water systems. It does not apply to closed cooling systems and once-through cooling water systems. This document applies only to systems that incorporate shell and tube heat exchangers with standard uncoated smooth tubes and cooling water on the tube side. This document does not apply to heat exchangers with shell-side water, plate and frame and/or spiral heat exchangers and other heat exchange devices. However, when the test conditions are properly set up to model the surface temperature and shear stress in more complex heat transfer devices, the test results can predict the results of operating heat exchangers of that design. The test criteria established in this document are not intended to govern the type of bench and pilot scale testing normally carried out by water treatment companies as part of their proprietary product development programmes. However, water treatment companies can choose to use the criteria in this document as guidelines in the development of their own product development test procedures.

Begin

2021-06-28

WI

00262352

Planned document number

DIN EN ISO 16784-1

Project number

06236184

Responsible national committee

NA 062-01-71 AA - Corrosion and corrosion protection  

Responsible european committee

CEN/TC 262 - Metallic and other inorganic coatings, including for corrosion protection and corrosion testing of metals and alloys  

Responsible international committee

ISO/TC 156/WG 17 - Corrosion in industrial cooling water  

draft standard

Corrosion of metals and alloys - Corrosion and fouling in industrial cooling water systems - Part 1: Guidelines for conducting pilot-scale evaluation of corrosion and fouling control additives for open recirculating cooling water systems (ISO/DIS 16784-1:2023); German and English version prEN ISO 16784-1:2023
2023-10
Order from DIN Media

previous edition(s)

Corrosion of metals and alloys - Corrosion and fouling in industrial cooling water systems - Part 1: Guidelines for conducting pilot-scale evaluation of corrosion and fouling control additives for open recirculating cooling water systems (ISO 16784-1:2006); German version EN ISO 16784-1:2008
2008-07

Order from DIN Media

Contact

Julia Listringhaus

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2123
Fax: +49 30 2601-42123

Send message to contact