Railway applications - Design for PRM use - Equipment and components on board rolling stock - Part 3: Clearways and internal doors; German and English version prEN 16585-3:2022
Abstract
This document describes the specific ‘Design for PRM use’ requirements applying to rolling stock and the assessment of those requirements. The following applies to this document: -The definitions and requirements describe specific aspects of ‘Design for PRM use’ required by persons with disabilities and persons with reduced mobility as defined in the PRM TSI. -This document defines elements which are universally valid for obstacle-free travelling relating to clearways and internal doors. The definitions and requirements of this standard are to be used for rolling stock applications. -This document only refers to aspects of accessibility for PRM passengers; it does not define non-PRM related requirements and definitions. -This document assumes that the rolling stock is in its defined operating condition. -Where minimum or maximum dimensions are quoted these are absolute NOT nominal requirements. The 'Equipment and components' standard is written in three parts: -Part 1 contains: -Toilets; -Part 2 contains: -Handholds; -Seats; -Wheelchair spaces; -This document is Part 3 and contains: -Clearways; -Internal doors.
Begin
2021-05-20
WI
00256974
Planned document number
DIN EN 16585-3
Project number
08701397
Responsible national committee
NA 087-00-11-02 UA - Vehicles and infrastructure for people with reduced mobility
Responsible european committee
CEN/TC 256/SC 4/WG 44 - Persons of Reduced Mobility (PRM)
draft standard
Railway applications - Design for PRM use - Equipment and components on board rolling stock - Part 3: Clearways and internal doors; German and English version prEN 16585-3:2022
2022-06
Order from DIN Media
