Abstract

This document specifies the safety requirements for rock drill rigs and rock reinforcement rigs designed for the following underground or surface operations: a) blast hole drilling; b) rock reinforcement and consolidation (injection holes, pipe roofing, netting, bolting); c) drilling for secondary breaking; d) dimensional stone drilling; e) mineral prospecting, e.g. utilizing core drilling or reverse circulation; f) water and methane drainage drilling; g) raise boring; when used by a well-trained operator in accordance with the information for use and where sufficient measures have been taken to prevent unauthorized entry of persons to the area where machines are working. NOTE Machines can be designed for more than one of the operations above. See ISO 22932-4 and ISO 22932-5 for vocabulary. This document is also applicable to earth-moving machinery as defined in ISO 6165, modified to become a rock drill rig or rock reinforcement rig. This document is not applicable to the following machines: drill rigs for soil and rock mixture, Kelly drill rigs and casing drivers, cable tool drill rigs, pre-armouring machines, sonic drill rigs; shaft sinking drill rigs, crane attached drill rigs, drill rigs on derricks, scaling machines, machines tramming or travelling at a speed greater than 20 km/h on level ground. This document deals with the relevant and significant hazards, hazardous situations or hazardous events, as listed in Annex D, when they are used as intended and under the conditions of misuse which are reasonably foreseeable by the manufacturer. This document is not applicable to machines manufactured before the date of its publication

Begin

2023-08-11

WI

00196046

Planned document number

DIN EN ISO 18758

Project number

06003955

Responsible national committee

NA 060-15-05 AA - Rock drill rigs  

Responsible european committee

CEN/TC 196/WG 8 - Rock drill rigs and reinforcement rigs  

Responsible international committee

ISO/TC 82/JWG 1 - Joint ISO/TC 82 - ISO/TC 127 WG : Rock drill rigs