• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information
  • Climate change Standards and specifications support climate targets

    More information
  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
Project

Plastics piping systems for water supply, and for drains and sewers under pressure - Polyethylene (PE) - Part 2: Pipes; German version EN 12201-2:2024

Abstract

DIN EN 12201-2 specifies the characteristics of pipes made from polyethylene (PE 100, PE 80 and PE 40) for buried and above ground applications, intended for the conveyance of water for human consumption, raw water prior to treatment, drainage and sewerage under pressure, vacuum sewer systems, and water for other purposes. It also specifies the test parameters for the test methods referred to in this standard. In conjunction with DIN EN 12201-1 and DIN EN 12201-3 to -5, it is applicable to PE pipes, their joints and to joints with components of PE and other materials intended to be used under the following conditions:a) allowable operating pressure, PFA, up to 25 bar );b) an operating temperature of 20 °C as a reference temperature;c) buried in the ground;d) sea outfalls;e) laid in water;f) above ground, including pipes suspended below bridges. DIN EN 12201 (all parts) covers a range of allowable operating pressures and gives requirements concerning colours and additives.

Begin

2021-01-05

WI

00155916

Planned document number

DIN EN 12201-2

Project number

11904358

Responsible national committee

NA 119-07-18-01 UA - Plastics piping components for water supply  

Responsible european committee

CEN/TC 155/WG 12 - Pressure systems of polyolefin material for gas supply, water supply and drainage and sewerage  

draft standard

Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 2: Pipes; German and English version prEN 12201-2:2021
2021-05
Order from DIN Media

previous edition(s)

Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 2: Pipes; German version EN 12201-2:2011+A1:2013
2013-12

Order from DIN Media

Contact

Saskia Hübner

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2722
Fax: +49 30 2601-42722

Send message to contact