Abstract

DIN EN 12201-1 specifies the general aspects of polyethylene (PE) pressure piping systems (mains and service pipes) for buried or above ground applications, intended for the conveyance of water for human consumption, raw water prior to treatment, drainage and sewerage under pressure, vacuum sewer systems, and water for other purposes. It also specifies the test parameters for the test methods referred to in this standard. In conjunction with DIN EN 12201-2 to -5, it is applicable to PE pipes, fittings, valves, their joints and to joints with components of other materials intended to be used under the following conditions:a) allowable operating pressure, PFA, up to 25 bar );b) an operating temperature of 20 °C as a reference temperature;c) buried in the ground;d) sea outfalls;e) laid in water;f) above ground, including pipes suspended below bridges. DIN EN 12201 (all parts) covers a range of allowable operating pressures and gives requirements concerning colours and additives.

Begin

2021-01-05

WI

00155915

Planned document number

DIN EN 12201-1

Project number

11904356

Responsible national committee

NA 119-07-18-01 UA - Plastics piping components for water supply  

Responsible european committee

CEN/TC 155/WG 12 - Pressure systems of polyolefin material for gas supply, water supply and drainage and sewerage  

draft standard

Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 1: General; German and English version prEN 12201-1:2021
2021-05
Order from DIN Media

previous edition(s)

Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 1: General; German version EN 12201-1:2011
2011-11

Order from DIN Media