• Hydrogen Technologies Standards form the basic framework for market ramp-up

    More information

  • Climate change Standards and specifications support climate targets

    More information

  • Smart Farming Standards and specifications are drivers for the digitalization of agriculture

    More information
 
Standards [CURRENT]

DIN EN ISO 4759-3
Tolerances for fasteners - Part 3: Washers for bolts, screws and nuts - Product grades A, C and F (ISO 4759-3:2016); German version EN ISO 4759-3:2016

Title (German)

Toleranzen für Verbindungselemente - Teil 3: Scheiben für Schrauben und Muttern - Produktklassen A, C und F (ISO 4759-3:2016); Deutsche Fassung EN ISO 4759-3:2016

Overview

This part of ISO 4759 specifies tolerances for flat washers of product grades A, C and F with nominal diameters of 1 mm to 150 mm inclusive, designed to be used in bolted joints in combination with bolts, screws, studs and nuts. This standard may be applied to non-flat washers however it does not include all the tolerances related to these washers. It applies to non-captive and captive washers, and to standard and non-standard washers. This document (EN ISO 4759:3:2016) has been prepared by Technical Committee ISO/TC 2 "Fasteners" in collaboration with CEN/TC 185 "Fasteners". The responsible German standardization committee is Working Committee NA 067-00-09-02 AK "Scheiben und Ringe" ("Washers and rings") at DIN Standards Committee Fasteners (FMV).

Document: references other documents

Responsible national committee

NA 067-00-11 AA - Washers and rings  

Responsible european committee

CEN/TC 185 - Fasteners  

Responsible international committee

ISO/TC 2/WG 13 - Washer and non-threaded fasteners  

Edition 2016-12
Original language German
Translation English
Price from 77.90 €
Order from DIN Media
Table of contents

Contact

Dipl.-Ing. (FH)

Holger Zernitz

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2051
Fax: +49 30 2601-42051

Send message to contact