Overview

This document (EN 13167:2012+A1:2015) has been prepared by Technical Committee CEN/TC 88 "Thermal insulating materials and products", the secretariat of which is held by DIN (Germany). This document includes Amendment 1 approved by CEN on 2014-12-15. This Amendment contains those clauses of the standard which are needed for the compliance of the European Standard with the Construction Products Regulation (CPR). This document is part of a package of interrelated standards for the specification of factory made thermal insulation products. This European Standard specifies the requirements for factory made wood wool (WW) products, with or without facings or coatings, which are used for the thermal insulation of buildings. The products are manufactured in the form of boards or slabs. This European Standard also specifies the requirements for the factory made composite products, made from wood wool in combination with other insulation materials. This European Standard includes wood-wool multi-layered insulation products. The instructions in Annex C shall be followed. This European Standard describes product characteristics and includes procedures and specifications for testing, evaluation of conformity, marking and labelling. Products covered by this European Standard are also used in prefabricated thermal insulation systems and composite panels. The properties of systems incorporating these products are not covered. This standard does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels and classes required for a given application are to be found in regulations or non-conflicting standards. Products with a declared thermal resistance lower than 0,15 m² K/W or a declared thermal conductivity greater than 0,100 W/(m·K) at 10 °C are not covered by this standard. This European Standard does not cover in situ insulation products and products intended to be used for the insulation of building equipment and industrial installations. This standard differs from DIN EN 13168:2013-03 as follows: a) an addition to the foreword; b) an addition in 3.2 "Symbols, units and abbreviated terms"; c) a new subclause 4.3.11 "Release of dangerous substances"; d) modification of Clause 7 "Assessment and Verification of the Constancy of Performance (AVCP)"; e) modification of Clause 8 "Marking and labelling"; f) modification of Annex B "Product type determination" (PTD) and "factory production control (FPC)"; g) a new Annex ZA. The responsible German standardization committee is Working Committee NA 005-56-60 AA "Wärmedämmstoffe (Spiegelausschuss zu CEN/TC 88 und WG 1 bis 9, WG 12 bis 21, ISO/TC 61/SC 10, ISO/TC 163 (teilweise), ISO/TC 163/SC 1 und SC 3)" ("Thermal insulating materials (Mirror Committee of CEN/TC 88 and WG 1 to 9, WG 12 to 21, ISO/TC 61/SC 10, ISO/TC 163 (partly), ISO/TC 163/SC 1 and SC 3)") at DIN Standards Committee Building and Civil Engineering (NABau).

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 005-56-60 AA - Thermal insulation materials (national mirror committee for CEN/TC 88 and WG 1 to 9, WG 12 to 16, WG 19 to 23, ISO/TC 61/SC 10, ISO/TC 163 (partly), ISO/TC 163/SC 1 and SC 3 (partly))  

Responsible european committee

CEN/TC 88/WG 2 - Coordinating group