Overview

This International Standard defines the general principles for the application of the time-of-flight diffraction (TOFD) technique for both detection and sizing of discontinuities in low alloyed carbon steel components. The TOFD technique can also be used for other types of materials provided the application of the TOFD technique is performed with necessary consideration of geometry, acoustical properties of the materials, and the sensitivity of the examination. Although it is applicable, in general terms, to discontinuities in materials and applications covered by ISO 16810, it contains references to the application on welds. This approach has been chosen for reasons of clarity as to the ultrasonic probe positions and directions of scanning. Unless otherwise specified in the referencing documents, the minimum requirements of this standard are applicable. Unless explicitly stated otherwise, this standard is applicable to the following product classes as defined in ISO 16811: - class 1, without restrictions; - classes 2 and 3, specified restrictions apply. The inspection of products of classes 4 and 5 requires special procedures, which are also addressed. The text of ISO 16828:2012 has been prepared by Technical Committee ISO/TC 135 "Non-destructive testing" of the International Organization for Standardization (ISO) and has been taken over as EN ISO 16828:2014 by Technical Committee CEN/TC 138 "Non-destructive testing", the secretariat of which is held by AFNOR (France). The responsible German body involved in its preparation is Working Committee NA 062-08-23 AA "Ultraschallprüfung" ("Ultrasonic testing") at DIN Standards Committee Materials Testing (NMP).

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 062-11-12 AA - Ultrasonic testing  

Responsible european committee

CEN/TC 138/WG 2 - Ultrasonic testing  

Responsible international committee

ISO/TC 135/SC 3 - Ultrasonic testing