Overview

This standard is the technical revision of the standard which has been published in 2010-01. The clauses "Normative references" and "Terms and definitions" as well as a new figure have been included in this revision. Furthermore, a note has been added in Table 1. This standard specifies burr heights ranges in dependence on the tensile strength of the material and the thickness of the workpiece and allocates them to various accuracy levels. This standard has been prepared by NA 026-00-03 AA "Stanzteile" ("Stamped parts") of the Springs, Stamped Parts and Moulded Parts Standards Committee (NAFS) at DIN, the German Institute for Standardization e. V. For further information about the NAFS, visit us on the Internet under www.nafs.din.de.

Document: references other documents

Responsible national committee

NA 026-00-03 AA - Stamped Parts