2. Services
3. Standards portals
4. Heat-generating equipment
5. Standards, projects and drafts

Standards, projects and drafts

Overview

This document specifies constructional, functional, testing, marking, sizing and documentation requirements of gas pressure regulators: - for inlet pressures up to 100 bar and nominal diameters up to DN 400; - for an operating temperature range from - 20 °C to +60 °C, which operate with fuel gases of the 1st and 2nd family as defined in EN 437, used in the pressure control stations in accordance with EN 12186 or EN 12279, in transmission and distribution networks and also in commercial and industrial installations. This document applies to regulators which use the pipeline gas as a source of control energy unassisted by any external power source. The regulator may incorporate a second regulator, used as monitor, complying with the requirements in this document. The regulator may incorporate a safety shut off device (SSD) complying with the requirements of EN 14382. The regulator may incorporate a creep (venting) relief device, complying with the requirements in Annex E and/or a vent limiter, complying with the requirements in Annex I. Controllers that meet the requirements of this document may be declared as complying with EN 334 and marked with the EN 334 mark. This document does not apply to: - regulators upstream from/on/in domestic gas-consuming appliances which are installed downstream of domestic gas meters; - regulators designed to be incorporated into pressure control systems used in service lines with volumetric flow rate up to 200 m³/h at normal conditions and inlet pressure up to 5 bar; - regulators for which a specific document exists (for example, EN 88-1 and EN 88-2, etcetera); - industrial process control valves in accordance with EN 1349. The informative Annex G of this document lists some suitable materials for pressure bearing parts, inner metallic partition walls, auxiliary devices, integral process and sensing lines, connectors and fasteners. Other materials may be used when complying with the restrictions given in Table 5. Continued integrity of gas pressure regulators is ensured by suitable surveillance checks and maintenance. For periodic functional checks and maintenance it is common to refer to national regulations/standards where existing or users/manufacturers practices. This document has introduced the reaction of the pressure regulators to the specified reasonable expected failures in terms of "fail close" and "fail open" pressure regulator types, but it should be considered that there are other types of failures whose consequences can bring to the same reactions (these risks are covered via redundancy as per EN 12186) and that residual hazards will be reduced by a suitable surveillance in use / maintenance. In this document, both pressure regulators that can be classified as "safety accessories" by themselves (monitors) in accordance with the Pressure Equipment Directive (2014/68/EU) as well as regulators that can be used to provide the necessary pressure protection through redundancy (for example, pressure regulator with integrated safety shut-off device, pressure regulator + in-line monitor, pressure regulator + safety shut off device) are considered. The provisions in this document are in line with the state of art at the moment of writing. This document does not intend to limit the improvement of actual provisions (materials, requirements, test methods, acceptance criteria etcetera) or the developing of new provisions for gas pressure regulators where they are suitable to ensure an equivalent level of reliability. Some clauses of this standard should be re-considered at the time when characteristics for nonconventional gases will be available. The document also contains environmental considerations. The responsible committee for this standard at DIN is NA 032-02-04-02 AK "Spiegelausschuss CEN/TC 235/WG 1" ("Mirror Committee CEN/TC 235/WG 1"). After its approval, this standard will be incorporated into DVGW Code of Practice "Gas".

Document: references other documents

Responsible national committee

NA 032-02-04-02 AK - Mirror Committee CEN/TC 235/WG 1  

Responsible european committee

CEN/TC 235/WG 1 - Safety shut-off devices, safety relief devices and small regulators with or without safety devices used in gas transmission and/or distribution.