ISO general purpose metric screw threads - Tolerances - Part 4: Limits of sizes for hot-dip galvanized external screw threads to mate with internal screw threads tapped with tolerance position H or G after galvanizing (ISO 965-4:1998)
Edition 2002-05

Methods of measurement for equipment used in digital microwave transmission systems - Part 2: Measurements on terrestrial radio-relay systems; Section 2: Antenna (IEC 60835-2-2:1994); German version EN 60835-2-2:1994
Edition 1994-12

Methods of test for screed materials - Part 5: Determination of wear resistance to rolling wheel of screed materials for wearing layer; German version EN 13892-5:2003
Edition 2003-09

Measurement and control; electrical temperature sensors; straight thermometers with interchangeable sensor units
Edition 1986-03

Methods of test for screed materials - Part 7: Determination of wear resistance to rolling wheel of screed materials with floor coverings; German version EN 13892-7:2003
Edition 2003-09

Agricultural tractors and machinery; electric power transmission; dimensions, requirements
Edition 1991-01

Round Screw Thread with Clearance and Steep Flank with Pitch 7 mm; Limiting Dimensions of Screw Threads and Allowances-Permissible Deviations and Permissible Wear of Screw Thread Gauges
Edition 1973-05

Hot applied joint sealants - Part 4: Test method for the determination of heat resistance; Change in penetration value; German version EN 13880-4:2003
Edition 2003-09

Laboratory glassware; volumetric glassware for gas analysis, gas burettes, azotometers, eudiometers, nitrometers
Edition 1978-10

Interface for serial measurement data communication - Part 3: Application services, messages (protocol data units) and protocols
Edition 1998-04