2. Getting involved
3. Standards Committees
4. NMP

DIN Standards Committee Materials Testing

Overview

This document provides guidelines and recommendations regarding the general principles of design that are appropriate for articles to be sherardized for corrosion protection. The protection afforded by the sherardized coating to the article will depend upon the method of application of the coating, the design of the article and the specific environment to which the article is exposed. The sherardized article can be further protected by application of additional coatings (outside the scope of this document), such as organic coatings (wet paints or powder coatings). When applied to sherardized articles, this combination of coatings is often known as a "duplex system". General guidance on this subject can be found in ISO 12944-5 and EN 13438. The maintenance of corrosion protection in service for steel with sherardized coatings is outside the scope of this document. Specific product-related requirements (such as for sherardized coatings on fasteners or tubes, etcetera) will take precedence over these general recommendations. This document (EN ISO 14713-3:2016) has been prepared by Technical Committee ISO/TC 107 "Metallic and other inorganic coatings", in collaboration with Technical Committee CEN/TC 262 "Metallic and other inorganic coatings", the secretariat of which is held by BSI. The responsible German committee is Working Committee NA 062-01-75 AA "Schmelztauchüberzüge" ("Hot dip coatings") at DIN Standards Committee Materials Testing (NMP).

Document: references other documents

Responsible national committee

NA 062-01-75 AA - Hot dip coatings  

Responsible european committee

CEN/TC 262/WG 2 - Hot dip galvanized coatings  

Responsible international committee

ISO/TC 107/SC 4 - Hot dip coatings (galvanized, etc.)