NA 119

DIN Standards Committee Water Practice

Project

Ductile iron pipes, fittings and accessories - External cement mortar coating for pipes - Requirements and test methods

Abstract

This document defines the requirements and test methods applicable to factory applied cement mortar coatings for the external corrosion protection of ductile iron pipes conforming to EN 545, EN 598 and EN 969 for use at operating temperatures up to 50 °C. NOTE Coatings according to this document are suitable for soils of all common corrosion loads and trenchless applications. Special activities on site such as joint protection, tapping, clamping, etc. could affect the corrosion protection properties of the cement mortar coating. These operations should be covered in the laying instructions supplied by the manufacturers of pipes, clamps, house connection saddles, etc. and any relevant users' procedures. Such instructions are not part of this document.

Begin

2020-05-19

WI

00203063

Planned document number

FprEN 15542

Responsible national committee

NA 119-07-17-01 UA - Cast iron pipes (CEN/TC 203)  

Responsible european committee

CEN/TC 203/WG 8 - Coatings for pipes, fittings and accessories  

draft standard

Ductile iron pipes, fittings and accessories - External cement mortar coating for pipes - Requirements and test methods
2021-12
Order from DIN Media

Ductile iron pipes, fittings and accessories - External cement mortar coating for pipes - Requirements and test methods
2023-10
Order from DIN Media

previous edition(s)

Ductile iron pipes, fittings and accessories - External cement mortar coating for pipes - Requirements and test methods
2008-03

Order from DIN Media

Contact

Saskia Hübner

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2722
Fax: +49 30 2601-42722

Send message to contact