2. Getting involved
3. Standards Committees
4. NATG

DIN Standards Committee Technical Fundamentals

Overview

This standard is the technical revision of the standard which has been published in 2010-01. This revision primarily includes the update of the normative references. This standard applies to bent parts from flat steel products for use in structural steelwork and mechanical engineering. This standard has been prepared by NA 026-00-03 AA "Stanzteile" ("Stamped parts") of the Springs, Stamped Parts and Moulded Parts Standards Committee (NAFS) at DIN, the German Institute for Standardization e. V. For further information about the NAFS, visit us on the Internet under www.nafs.din.de.

Document: references other documents

Responsible national committee

NA 026-00-03 AA - Stamped Parts