2. Getting involved
3. Standards Committees
4. FSF

DIN Standards Committee Railway

Overview

Wear, failures and other damages affect the operational safety of railway vehicles. Depending on the tribological behaviour, the operational parameters and the current state of the railway vehicles and depending on the economic efficiency, a maintenance system has to be specified which ensures that the required technical target state is satisfied. The standards of the complete works "State of railway vehicles" represent a uniform and system-compatible normative document which specifies rules for the operation and maintenance of standard gauge railway vehicles. The general scope of all standards of the complete works is specified in DIN 27200, Clauses 1 and 3.1, and all documents of the complete works are listed in DIN 27200, Supplement 1. DIN 27202 "State of railway vehicles - Superstructure and special equipment of vehicles" consists of: - Part 1: Vehicle superstructure - Part 2: Buffing and draw gear - Part 3: Steps, handles, hand rails, ladders, railings - Part 4: Gangways - Part 5: Moveable components of vehicle superstructure and doors (except doors of passenger areas) - Part 6: Safety equipment for load and transport protection - Part 7: Rancher - Part 8: Freight containers/Tanks - Part 9: Installations which contain substances dangerous to water as well as tanks and pipe systems for flammable substances - Part 10: Measurement of superstructures. This standard DIN 27202-8 "State of railway vehicles - Superstructure and special equipment of vehicles - Part 8: Freight containers/Tanks" applies for tanks of tank wagons, freight containers of freight wagons and medium containers which serve for transportation of solid, liquid and gaseous goods. These include for example tanks for petroleum products, tanks for chemical products, tanks for compressed gases, freight containers with pneumatic drain for powdery goods and medium containers. This standard also covers the assemblies saddle, fittings, insulation/lining, heating and electrical equipment. Additional requirements may be applicable to freight containers carrying goods. The following modifications have been made with respect to DIN 27202-8:2004-09: a) the foreword and scope have been adapted; b) the normative references have been revised; c) note regarding the treatment of defects according to DIN 27201-11 to raise the technical target state to the basic requirement; d) revision of the technical target state in Table 1 - Freight containers/tanks; e) informative Annex for the differentiation freight containers/tanks has been incorporated; f) editorially revised. This document has been prepared by Subcommittee NA 087-00-15-02 UA "Fahrzeugaufbau und Sondereinrichtungen" ("Superstructure and special equipment of vehicles") of Working Committee NA 087-00-15 AA "Zustand der Eisenbahnfahrzeuge" ("State of railway vehicles") of the Railway Standardization Committee (FSF), in coordination with other working committees of the FSF and the German Commission for Electrical, Electronic and Information Technologies (DKE).

Document: references other documents

Responsible national committee

NA 087-00-15-02 UA - Superstructure and special equipment of vehicles