DIN Standards Committee Railway
Railway applications - Design for PRM use - Equipment and components on board rolling stock - Part 2: Elements for sitting, standing and moving; German version FprEN 16585-2:2024
Abstract
This document describes the specific 'Design for PRM use' requirements applying to rolling stock and the assessment of those requirements. The following applies to this document: - The definitions and requirements describe specific aspects of 'Design for PRM use' required by persons with disabilities and persons with reduced mobility as defined in the PRM TSI - This document defines elements which are universally valid for obstacle-free travelling relating to elements for sitting, standing and moving. The definitions and requirements of this document are to be used for rolling stock applications - This document only refers to aspects of accessibility for PRM passengers; It does not define general requirements and general definitions - This document assumes that the rolling stock is in its defined operating condition - Where minimum or maximum dimensions are quoted these are absolute NOT nominal requirements. The 'Equipment and components' standard is written in three parts: -Part 1 contains: -toilets; -This document is Part 2 and contains: -handholds; -seats; -wheelchair spaces; -Part 3 contains: -clearways; -internal doors.
Begin
2021-05-20
WI
00256969
Planned document number
DIN EN 16585-2
Project number
08701396
Responsible national committee
NA 087-00-11-02 UA - Vehicles and infrastructure for people with reduced mobility
Responsible european committee
CEN/TC 256/SC 4/WG 44 - Persons of Reduced Mobility (PRM)
draft standard
Railway applications - Design for PRM use - Equipment and components on board rolling stock - Part 2: Elements for sitting, standing and moving; German and English version prEN 16585-2:2022
2022-06
Order from DIN Media
