2. Getting involved
3. Standards Committees
4. FNNE

DIN Standards Committee Nonferrous Metals

Overview

This document specifies the technical conditions for inspection and delivery of wrought aluminium and wrought aluminium alloy sheet, strip and plate for general applications. It also includes provisions for ordering and testing.
It applies to products with a thickness over 0,20 mm up to and including 400 mm.
For many special applications of aluminium strip, sheet and plate, specific European Standards exist, where different or additional requirements are formulated and the appropriate alloys and tempers are selected: see Annex A. Most of these special European Standards refer to provisions of this document.
The selection of the relevant special European Standards is under the responsibility of the purchaser.
Whenever the application involves special properties, such as corrosion resistance, toughness, fatigue strength, surface appearance and welding properties, the user should consult the supplier and consider the relevant special European Standard, as applicable.
This document has been prepared by Working Group WG 7 "Sheet strip and plate" (secretariat: AFNOR, France) within Technical Committee CEN/TC 132 "Aluminium and aluminium alloys" (secretariat: AFNOR, France) of the European Committee of Standardization (CEN) with German collaboration.
The national interests in the preparation of this standard were represented by Working Committee NA 066-01-06 AA "Bänder, Bleche, Platten" ("Sheet, strip and plate") at DIN Standards Committee Nonferrous Metals (FNNE).

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 066-01-06 AA - Sheet, strip and plate  

Responsible european committee

CEN/TC 132/WG 7 - Sheets, strips and plates