DIN Standards Committee Nonferrous Metals
DIN EN ISO 7668
Anodizing of aluminium and its alloys - Measurement of specular reflectance and specular gloss of anodic oxidation coatings at angles of 20 degrees, 45 degrees, 60 degrees or 85 degrees (ISO 7668:2010); German version EN ISO 7668:2010
Anodisieren von Aluminium und Aluminiumlegierungen - Messung des gerichteten Reflexionsgrades und des Spiegelglanzes von anodisch erzeugten Oxidschichten bei Winkeln von 20°, 45°, 60° oder 85° (ISO 7668:2010); Deutsche Fassung EN ISO 7668:2010
Overview
This standard specifies methods for the measurement of specular relectance and specular gloss of flat samples of anodized aluminium using geometries of 20° (Method A); 45° (Method B), 60° (Method C), and 85° (Method D) and of specular reflectance by an additional 45° method (Method E) employing a narrow acceptance angle. The methods described are intended mainly for use with clear anodized surfaces. They can be used with colour-anodized aluminium, but only with similar colours. The following principle is used: The specular reflectance and the specular gloss of anodized aluminium surfaces are measured under defined conditions using, as required, geometries of 20°, 45°, 60° or 85°. The International/European Standard has been prepared under the leadership of ISO/TC 79/SC 2/WG 16 "Revisions for Systematic reviewed TC 79/SC 2 ISO standards" (secretariat: JISC, Japan) in a parallel procedure with CEN/TC 132/WG 15 "Aluminium anodisation" (secretariat: BSI, United Kingdom). On the national level, the responsible Working Committee is NA 066-01-09 AA "Anodisch oxidiertes Aluminium" ("Aluminium anodisation") of FNNE.
Document: references other documents
Responsible national committee
NA 066-01-09 AA - Surface treatment of aluminium
