2. Getting involved
3. Standards Committees
4. FNNE

DIN Standards Committee Nonferrous Metals

Overview

This standard specifies methods of assessing the quality of sealed anodic oxidation coatings on aluminium and its alloys by measurement of the loss of mass after immersion in phosphoric acid/chromic acid solution. The standard consists of the following two methods: - Method 1: assessment of quality of sealed anodic oxidation coatings on aluminium and its alloys by measurement of the loss of mass after immersion in phosphoric acid/chromic acid solution, without prior acid treatment. - Method 2: assessment of quality of sealed anodic oxidation coatings on aluminium and its alloys by measurement of the loss of mass after immersion in phosphoric acid/chromic acid solution with prior acid treatment. Method 1 is applicable to all anodic oxidation coatings intended for decorative or protective purposes or where resistance to staining is important. Method 2 is particularly applicable to anodic oxidation coatings intended for architectural purposes. For less severe applications, Method 1 is more suitable. The methods are not applicable for - hard-type anodic oxidation coatings which normally are not sealed - anodic oxidation coatings that have been sealed only in dichromate solutions - anodic oxidation coatings produced in chromic acid solutions - anodic oxidation coatings that have undergone a treatment to render them hydrophobic. The methods are destructive and can serve as reference methods in case of doubt or dispute regarding the results of the test for loss of absorptive power (ISO 2143) or the measurement of admittance (ISO 2931). The International/European Standard has been prepared under the leadership of ISO/TC 79/SC 2/WG 16 "Revisions for systematic reviewed TC 79/SC 2 ISO standards" (secretariat: JISC, Japan) in a parallel procedure with CEN/TC 132/WG 15 "Aluminium anodisation" (secretariat: BSI, United Kingdom). The responsible standardization committee is Working Committee NA 066-01-09 AA "Anodisch oxidiertes Aluminium" ("Aluminium anodisation") of FNNE.

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 066-01-09 AA - Surface treatment of aluminium  

Responsible european committee

CEN/TC 132 - Aluminium and aluminium alloys