2. Getting involved
3. Standards Committees
4. FNNE

DIN Standards Committee Nonferrous Metals

Overview

This standard specifies a method for specifying decorative and protective anodic oxidation coatings on aluminium (including aluminium-based alloys). It defines the characteristic properties of anodic oxidation coatings, lists methods for checking the characteristic properties, specifies the minimum requirements, and gives information on the grades of aluminium suitable for anodizing and the importance of pretreatment to ensure the required appearance or texture of the finished work. It is not applicable to: - non-porous oxidation coatings of the barrier layer type - coatings produced by chromic acid or phosphoric acid anodizing - oxidation coatings intended merely to prepare the substrate for subsequent application of organic coatings or electrodeposition of metals - hard anodic oxidation coatings used mainly for engineering purposes, for which abrasion and wear resistance are the primary characteristics (see ISO 10074). The International Standard has been prepared under the leadership of ISO/TC 79/SC 2/WG 15 "General specifications for anodic oxide coatings on aluminium" (secretariat: JISC, Japan) in a parallel procedure with CEN/TC 132/WG 15 "Aluminium anodisation" (secretariat: BSI, United Kingdom). On the national level the responsible Working Committee is NA 066-01-09 AA "Anodisch oxidiertes Aluminium" ("Aluminium anodisation") of FNNE.

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 066-01-09 AA - Surface treatment of aluminium  

Responsible european committee

CEN/TC 132 - Aluminium and aluminium alloys