2. Getting involved
3. Standards Committees
4. FNK

DIN Standards Committee Plastics

Overview

The European Standard EN 12666-1:2005+A1:2011 which specifies requirements and test methods for pipes, fittings and polyethylene (PE) piping systems used for buried piping systems for non-pressure drainage and sewerage, contains modifications for harmonization of the requirements in the standards on drains and sewers agreed upon by CEN/TC 155. The significant modifications with respect to DIN EN 12666-1:2006 are as follows: - introduction of two new dimensions, 560 mm and 710 mm; - introduction of a new ring stiffness class SN 16; - update of the references in clause 2; - introduction of pipe series S in 3.3; - introduction of pipe series S, a new footnote a) and a new note in Table 3; - introduction of a new watertightness test for fabricated fittings; - deletion of Long Term Performance of TPE seals - Table 12 and 10.3; - corrections of misprints in Tables 13 and 14, marking of pipes and fittings; - introduction of a new informative Annex B, product standards of components that can be connected to components conforming to this standard; - update and modification of the bibliography. The consolidated version EN 12666-1:2005+A1:2011 has been prepared by CEN/TC 155 "Plastics piping systems and ducting systems" the secretariat of which is held by NEN (Netherlands). The responsible German committee is Joint Working Committee NA 119-05-28-08 GUA "Vollwandrohre für Abwasserkanäle und -leitungen" ("Solid wall pipes for drainage and sewerage") of the Water Practice Standards Committee.

Document: references other documents

Document: referenced in other documents

Responsible national committee

NA 119-05-40 GA - Joint working committee NAW/FNK: Plastic pipes for underground drainage and sewerage  

Responsible european committee

CEN/TC 155/WG 13 - Buried Thermoplastics piping systems for surface-water and foul-water drains and sewers