DIN Standards Committee Plastics
DIN EN ISO 10350-2
Plastics - Acquisition and presentation of comparable single-point data - Part 2: Long-fibre-reinforced plastics (ISO 10350-2:2011); German version EN ISO 10350-2:2011
Kunststoffe - Ermittlung und Darstellung vergleichbarer Einpunktkennwerte - Teil 2: Langfaserverstärkte Kunststoffe (ISO 10350-2:2011); Deutsche Fassung EN ISO 10350-2:2011
Overview
ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions or along different directions in the material. The properties included are those presented conventionally in manufacturers' data sheets.
This part of the standard applies to reinforced thermoplastic and thermosetting materials where the reinforcement fibres are either discontinuous with a fibre length prior to processing greater than 7,5 mm or continuous (for example, fabric, continuous-strand mat or unidirectional plastics). ISO 10350-1 deals specifically with unreinforced and filled plastics, including those using fibres less than 7,5 mm in length.
The international final draft ISO/FDIS 10350-2:2010 has been prepared by ISO/TC 61/SC 2/WG 8 "Forms of data presentation" (secretariat: BSI, United Kingdom). CEN/TC 249 "Plastics", the secretariat of which is held by the NBN (Belgium) is responsible for the European final draft. On the national level, the Committee responsible for the standard is Working Committee NA 054-01-02 AA "Mechanische Eigenschaften und Probekörperherstellung" ("Mechanical properties and preparation of test specimens") of the FNK.
Document: references other documents
Document: referenced in other documents
Responsible national committee
NA 054-01-02 AA - Mechanical properties and preparation of test specimens