NA 054

DIN Standards Committee Plastics

Project

Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials (ISO/DIS 10350-1:2024); German and English version prEN ISO 10350-1:2024

Abstract

The ISO 10350 series identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets. ISO 10350-1 applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that may be injection- or compression-moulded or prepared as sheets of specified thickness. For the purposes of ISO 10350-1, long-fibre-reinforced plastics are considered to have fibre lengths greater than 7,5 mm prior to moulding.

Begin

2022-11-01

WI

00249A54

Planned document number

DIN EN ISO 10350-1

Project number

05402252

Responsible national committee

NA 054-01-02 AA - Mechanical properties and preparation of test specimens  

Responsible european committee

CEN/TC 249 - Plastics  

Responsible international committee

ISO/TC 61/SC 2/WG 8 - Forms of data presentation  

draft standard

Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials (ISO/DIS 10350-1:2024); German and English version prEN ISO 10350-1:2024
2024-07
Order from DIN Media

previous edition(s)

Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials (ISO 10350-1:2017); German version EN ISO 10350-1:2017
2018-03

Order from DIN Media

Contact

Linda Grosskopp

Am DIN-Platz, Burggrafenstr. 6
10787 Berlin

Tel.: +49 30 2601-2638
Fax: +49 30 2601-42638

Send message to contact