DIN Standards Committee Fasteners
Fasteners - Hot dip galvanized coatings
Abstract
ISO 10684:2004 specifies material, process, dimensional and some performance requirements for hot dip spun galvanized coatings applied to coarse threaded steel fasteners from M8 up to and including M64 and for property classes up to and including 10.9 for bolts, screws and studs and 12 for nuts. It is not recommended to hot dip galvanize threaded fasteners in diameters smaller than M8 and/or with pitches below 1,25 mm.
ISO 10684:2004 primarily concerns the spun hot dip galvanizing of threaded steel fasteners, but it may also be applied to other threaded steel parts. The specifications given in this document may also be applied to non-threaded steel parts such as washers.
Begin
2024-11-06
WI
00185455
Planned document number
DIN EN ISO 10684 rev
Project number
06702448
Responsible national committee
NA 067-00-06 AA - Surface coatings of fasteners
Responsible european committee
Responsible international committee
ISO/TC 2/SC 14 - Surface coatings
