DIN Standards Committee Iron and Steel
Steel for the reinforcement of concrete - Weldable reinforcing steel - General
Abstract
1.1 This document specifies general requirements and definitions for the essential characteristics of weldable reinforcing steel used for the reinforcement of concrete structures, delivered as finished products in the form of: - bars (including those produced by the reinforcing steel manufacturer from coil); - coils; - sheets of factory-made machine-welded fabric; - lattice girders. 1.2 Steels according to this document have a ribbed, indented or smooth surface. NOTE 1 The protrusions between indentations of indented reinforcing steel have the same function as transverse ribs of ribbed reinforcing steel. There is no definition which specifies the difference between ribbed and indented surface geometry. Therefore, in this document, the same bond parameters are used for ribbed and indented steel. 1.3 This document does not apply to: - non-weldable reinforcing steel; - galvanized reinforcing steel; - epoxy-coated reinforcing steel; - corrosion resistant reinforcing steel; - prestressing steels; - indented strip; - further processing by a processor, e.g. de-coiling/straightening, cutting or cutting and bending. NOTE 2 Further processing could influence some essential characteristics of the product.
Begin
2022-02-01
WI
EC104043
Planned document number
prEN 10080
Responsible national committee
NA 021-00-03 AA - Reinforcing and pre-stressing steel
Responsible european committee
CEN/TC 459/SC 4/WG 1 - Weldable reinforcing steels
draft standard
Steel for the reinforcement of concrete - Weldable reinforcing steel - General
2023-01
Order from DIN Media
previous edition(s)
Steel for the reinforcement of concrete - Weldable reinforcing steel - General
2005-05
