2. Getting involved
3. Standards Committees
4. DKE

DKE German Commission for Electrical, Electronic & Information Technologies of DIN and VDE

Overview

This part of IEC 60793 is applicable to optical fibre sub-categories A1a, A1b, and A1d. These fibres are used or can be incorporated in information transmission equipment and optical fibre cables. Sub-category A1a applies to 50/125 mm graded index fibre. Three bandwidth grades are defined as models A1a.1, A1a.2 and A1a.3. Each of these bandwidth grades is defined for two levels of macrobend loss performance that are distinguished by "a" or "b" suffix. Those models with suffix "a" are specified to meet traditional macrobend loss performance levels. Those models with suffix "b" are specified to meet enhanced macrobend loss (that is, lower loss) performance levels. Sub-category A1b applies to 62,5/125 mm graded index fibre and sub-category A1d applies to 100/140 mm graded index fibre. Other applications include, but are not restricted to, the following: - short reach, high bit-rate systems in telephony, distribution and local networks carrying data, voice and/or video services; - on-premises intra-building and inter-building fibre installations including data centres, local area networks (LANs), storage area networks (SANs), private branch exchanges (PBXs), video, various multiplexing uses, outside telephone cable plant use, and miscellaneous related uses. Three types of requirements apply to these fibres: - general requirements, as defined in IEC 60793-2; - specific requirements common to the category A1 multimode fibres covered in this document and which are given in Clause 3; - particular requirements applicable to individual fibre sub-categories and models, or specific applications, which are defined in the normative specification annexes. The standard differs from DIN EN 60793-2-10 (VDE 0888-321):2011-11 as follows: a) inclusion of macrobend mode fibres A1a.1b, A1a.2b and A1a.3b. b) inclusion of test wavelengths and sample lengths for core diameter (CD), inclusion of numerical aperture (NA), differential mode delay (DMD) and threshold values for CD and NA. c) Inclusion of a sample length for the bandwidth at 850 nm for A1a and A1b fibres. The responsible committee is DKE/UK 412.6 "Lichtwellenleiter und Lichtwellenkabel" ("Optical fibres and fibre cables") of the DKE (German Commission for Electrical, Electronic and Information Technologies) at DIN and VDE.

Document: references other documents

Responsible national committee

DKE/UK 412.6 - Lichtwellenleiter und Lichtwellenleiterkabel