NA 022

DKE German Commission for Electrical, Electronic & Information Technologies of DIN and VDE

Standards [CURRENT]

DIN EN 61000-4-13 ; VDE 0847-4-13:2016-10
Electromagnetic compatibility (EMC) - Part 4-13: Testing and measurement techniques - Harmonics and interharmonics including mains signalling at a.c. power port, low frequency immunity tests (IEC 61000-4-13:2002 + A1:2009 + A2:2015); German version EN 61000-4-13:2002 + A1:2009 + A2:2016

Title (German)

Elektromagnetische Verträglichkeit (EMV) - Teil 4-13: Prüf- und Messverfahren - Prüfungen der Störfestigkeit am Wechselstrom-Netzanschluss gegen Oberschwingungen und Zwischenharmonische einschließlich leitungsgeführter Störgrößen aus der Signalübertragung auf elektrischen Niederspannungsnetzen (IEC 61000-4-13:2002 + A1:2009 + A2:2015); Deutsche Fassung EN 61000-4-13:2002 + A1:2009 + A2:2016

Overview

This standard contains the German version of European Standard EN 61000-4-13:2002 + A1:2009 + A2:2016 and is identical to International Standard IEC 61000-4-13:2002 and its Amendment 1:2009 and its Amendment 2:2015. It describes the testing of immunity of electrical and electronic equipment (devices) at the AC power port against harmonics and interharmonics including conducted disturbances from signal transmission on low-voltage electrical lines. It applies to equipment with an input current 16 A per conductor intended for connection to a 50 Hz/60 Hz low-voltage supply network. In addition to required definitions, it specifies recommended test levels, test equipment, test setup, and test procedure, as well as provisions for the test report and evaluation of test results. The following test procedures are described within the scope of this standard: - testing with individual harmonics and interharmonics with a specified sequence of test levels; - testing with the harmonic combinations "flat curve" and "overshoot" - testing with frequency sweep; - testing with the values from the so-called master curve. Two flowcharts are used to explain the sequence in which the individual test procedures are to be applied. The annexes contain information on the impedance network used according to IEC 60725, which is connected between the voltage source and the DUT, on the resonance point at which resonances are caused by harmonic and interharmonic currents, and describe the electromagnetic environment classes used as a basis in the standard. Compared with the previous edition, the ripple control signals used in some countries in the form of the so-called "master curve" have been included in 4.1.3, among other things. Furthermore, the information in 4.1.3 and 4.2.3 on the frequency range of signal transmission on low-voltage electrical installations has been extended downwards to 100 kHz. The responsible committee is DKE/UK 767.1 "Niederfrequente leitungsgeführte Störgrößen" ("Low-frequency conducted disturbance variables") of the DKE (German Commission for Electrical, Electronic and Informational Technologies) at DIN and VDE.

Document: references other documents

Document: referenced in other documents

Responsible national committee

DKE/UK 767.1 - Niederfrequente leitungsgeführte Störgrößen  

Edition 2016-10
Original language German
Price from 79.97 €
Table of contents

Contact

Kai Jagielski

Merianstr. 28
63069 Offenbach am Main

Tel.: +49 69 6308-351

Send message to contact