DKE German Commission for Electrical, Electronic & Information Technologies of DIN and VDE
DIN EN ISO 6520-2
Welding and allied processes - Classification of geometric imperfections in metallic materials - Part 2: Welding with pressure (ISO 6520-2:2013); Trilingual version EN ISO 6520-2:2013
Schweißen und verwandte Prozesse - Einteilung von geometrischen Unregelmäßigkeiten an metallischen Werkstoffen - Teil 2: Pressschweißungen (ISO 6520-2:2013); Dreisprachige Fassung EN ISO 6520-2:2013
Overview
This International Standard collects and classifies the possible imperfections in welds made with pressure. A uniform designation is specified. Only the type, shape, and dimensions of the different imperfections caused by welding with pressure are included. Metallurgical deviations are not taken into account. Imperfections produced other than by the welding operation, such as additional stresses, loads or environmental factors, are not covered by this standard. Information concerning the consequences of the imperfections mentioned and the use of particular structures is not given, because this depends on the specific requirements of the joint. The committee responsible for this standard is Working Committee NA 092-00-06 AA "Darstellung und Begriffe (DVS AG I 4)" ("Representation and terms (DVS AG I 4)") at DIN.
Document: references other documents
Document: referenced in other documents
Responsible national committee
NA 092-00-12 AA - Resistance welding (DVS AG V 3)
